We have a Makino U3 H.E.A.T
Maximum Workpiece Size 770 x 590 x 220 mm Tall – 600kg
Cutting envelope X370, Y 270, Z220
Wire cutting is a special process with the following advantages:
Complex shapes that would otherwise be difficult to produce with conventional cutting tools.
Extremely hard material to very close tolerances.
Very small work pieces where conventional cutting tools may damage the part from excess cutting tool pressure.
There is no direct contact between tool and work piece. Therefore, delicate sections and weak materials can be machined without perceivable distortion.
A good surface finish can be obtained; a very good surface may be obtained by redundant finishing paths.
Very fine holes can be attained.
Tapered holes may be produced.